『Plastic tube rotor flowmeter』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)
1. Introduction to Plastic Rotary Flow Meter
The main part of the cone tube of LZB series plastic tube rotary flow meter is made of AS and ABS plastic, which has good corrosion resistance, and has the characteristics of structural compatibility, small volume, light weight, and the cone tube is not easy to break. Plastic tube rotor flowmeter can be widely used in industrial sectors such as chemical, environmental protection, and food. The characteristic of the shirt is that it is not wear-resistant and corrosion-resistant. It can be attached with specific scales, calibrated sizes, measurement ranges, and measuring tube materials, all of which have been marked on the measuring rubber tube. The connection methods can be divided into four types: plug-in, welding, threaded, and flange connection.
2. Flow rate of metering pump
3. Installation and use method of plastic tube rotor flowmeter
The installation and use method of LZS series plastic tube rotor flowmeter is as follows:
1. Installation method of Kaikai Brother: Connection method: Use ABS or PVC plastic tube, insert it directly into the flowmeter interface with special adhesive and fix it with adhesive.
. Flange connection: If it needs to be connected to a metal pipeline, ABS or PVC flanges should be used to bond the flowmeter first, and then the flange should be connected to the metal pipeline to ensure sealing. Installation direction and angle perpendicular installation: The flowmeter must be installed vertically on the pipeline, with a tilt angle of less than 5 °, otherwise measurement errors may occur due to uneven force on the rotor. Direction identification: During installation, it is necessary to ensure that the flow dire
2. Before use, check the range matching to confirm that the measurement range of the instrument matches the actual working conditions. The maximum instantaneous flow rate of the measured medium should be less than the upper limit of the flowmeter to avoid damage to the rotor or sensor caused by exceeding the range.
. Medium parameter pressure: The pressure of the measured medium should be within the maximum working pressure range allowed by the flowmeter (usually indicated on the nameplate or instruction manual). Temperature: The medium temperature should comply with the working temperature range of the flowmeter (such as PVC material is generally suitable for -10 ℃ to 60 ℃, ABS material is suitable for -20 ℃ to 80 ℃), to prevent material deformation or seal failure. After the installation of the sealing inspection is completed, slowly open the valve and check if there is any leakage at the sealing point of the cone tube. If leakage is found, tighten the nut slightly; If there is still leakage, the seal (such a
Hot Blog
Related AD
